Expression Pedal - Decibel Eleven Switch Doctor Operation Manuals

Expression Pedal

An expression pedal can be used to send MIDI Continuous Controller data via the MIDI
OUT jack. A standard passive expression pedal can be connected to the rear panel
EXP. PEDAL jack using a standard stereo 1/4" cable (tip-ring-sleeve).
It is also possible to use a volume pedal as an expression pedal by connecting with a
standard "insert" cable as shown (do not use an active or battery powered pedal).
A third option for the expression pedal is to use a passive single-pole switch in the
EXP. PEDAL jack. This allows for a dedicated switch for sending MIDI Continuous
Controller ON/OFF messages. Use a cable connected as shown below:
For details on setting up and enabling the expression pedal for MIDI Continuous
Controller use, see the SETUP MODE– PDL section on page 19.
5