Programming Presets - Decibel Eleven Switch Doctor Operation Manuals

PROGRAMMING PRESETS

While in Preset Mode, first select the preset to be programmed. Then, press and hold
the EDIT switch until the blue EDIT LED lights. The display will show the first enabled
function to be programmed. Use the ▲ and ▼ footswitches to step through the
enabled functions to be programmed. Refer to the specific instructions for each
function type below:
Please note that only MIDI functions that are enabled in Setup Mode will be visible
(the bypass loops and the control function switches are always shown). The following
instructions describe the editing procedure for all of the possible MIDI functions,
whether they are enabled or not:
PC.1 (MIDI Program Change 1)
Press the ► switch to edit the MIDI Program Change number to send on the MIDI
Channel assigned to Program Change 1 (PC1) in Setup Mode . To disable sending PC1
for this preset, set to OFF.
PC.2 (MIDI Program Change 2)
Press the ► switch to edit the MIDI Program Change number to send on the MIDI
Channel assigned to Program Change 2 (PC2) in Setup Mode . To disable sending PC2
for this preset, set to OFF.
PC.3 (MIDI Program Change 3)
Press the ► switch to edit the MIDI Program Change number to send on the MIDI
Channel assigned to Program Change 3 (PC3) in Setup Mode. To disable sending PC3
for this preset, set to OFF.
CC.A (MIDI Control Changes A) - OR – NT.A (MIDI Note A)
As MIDI CC messages: Use the bottom row switches 1,2,3,4 to set the ON or OFF
states for each of the four controller switches assigned to Continuous Controller
Switches A (CCA) in Setup Mode. To disable sending CCA data for this preset, press
switches 1 and 4 simultaneously. The numeric display will begin to flash CC.A
indicating that no CCA controller data will be sent with this preset.
As MIDI Note messages: Use the bottom row switches 1,2,3,4 to set the MIDI Notes to
send for this preset. MIDI Notes message data is only sent for switches that are ON. A
switch that is OFF is not sent.
22