Table of Contents
Advertisement
PC.3 (MIDI Program Change 3)
Program Change 3 is fully programmable per preset. MIDI messages use numbers 0 to
127 for program changes. Since most devices label their presets from 1 to 128, the
Switch Doctor displays them as 1 to 128. The actual MIDI message sends as 0 to 127.
Press the ► switch to view the current MIDI Channel for Program Change 3. Use the
+ / - switches to edit the current channel. Set to OFF to disable this program change.
CC.A (MIDI Continuous Control switches A)
Sets the MIDI Channel and the MIDI numbers and 'ON' values for each of four CC or
Note messages.
Press the ► switch to view the current MIDI Channel. Use the + / - switches to edit the
current channel. Set to OFF to disable using these continuous controllers.
Press the ► switch again to display the first of four Continuous Controller numbers for
this MIDI Channel. The
switches is being programmed. Use ► to advance to the next switch and ◄ to return
to the previous switch. Use the +/- switches to set the data for each switch.
When programming a switch, it's LED will light. The first number shown is the 3-digit
MIDI Number. Set this to the CC or Note Number for this switch. Then press the ►
switch to advance to the MIDI Value for this switch (whenever the MIDI Value is
displayed it is always followed by a decimal point to differentiate it from the MIDI
Number). Enter the 3-digit value for this switch. This is the MIDI Value that will be sent
for this message when the switch is 'ON'. If it is being used as an ON/OFF function
switch, the value should typically be 127.
CC.B (MIDI Continuous Control switches B)
Sets the MIDI Channel and the MIDI numbers and 'ON' values for each of four CC or
Note messages.
Press the ► switch to view the current MIDI Channel. Use the + / - switches to edit the
current channel. Set to OFF to disable using these continuous controllers.
Press the ► switch again to display the first of four Continuous Controller numbers for
this MIDI Channel. The
switches is being programmed. Use ► to advance to the next switch and ◄ to return
to the previous switch. Use the +/- switches to set the data for each switch.
When programming a switch, it's LED will light. The first number shown is the 3-digit
MIDI Number. Set this to the CC or Note Number for this switch. Then press the ►
switch to advance to the MIDI Value for this switch (whenever the MIDI Value is
displayed it is always followed by a decimal point to differentiate it from the MIDI
red
LED above each switch number indicates which of the four
red
LED above each switch number indicates which of the four
- OR- NT.a (MIDI Note On A)
- OR- NT.b (MIDI Note On B)
18
Advertisement
Table of Contents
