Table of Contents
Advertisement
CC.B (MIDI Control Changes B) - OR – NT.B (MIDI Note B)
As MIDI CC messages: Use the bottom row switches 1,2,3,4 to set the ON or OFF
states for each of the four controller switches assigned to Continuous Controller
Switches B (CCB) in Setup Mode. To disable sending CCB data for this preset, press
switches 1 and 4 simultaneously. The numeric display will begin to flash CC.b
indicating that no CCB controller data will be sent with this preset.
As MIDI Note messages: Use the bottom row switches 1,2,3,4 to set the MIDI Notes to
send for this preset. MIDI Notes message data is only sent for switches that are ON. A
switch that is OFF is not sent.
Nte (MIDI Note-On)
Use the bottom row switches 1,2,3,4 to set which notes (assigned in Setup Mode) to
send a MIDI Note-On message for. If no switches are ON, then no MIDI Note data is
sent for this preset.
LPS (Bypass Loops)
Set the pedal bypass loop states using the bottom row switches. To ignore the pedal
bypass loops and create a preset that does not alter their states, press switches 1 and
4 simultaneously. The numeric display will begin to flash LPS to indicate that the loop
states will not be changed with this preset.
Fns (Function Switches)
Set the function switch states using the bottom row switches 1 and 2. To ignore the
function switches and create a preset that does not alter their states, press switches 1
and 4 simultaneously. The numeric display will begin to flash Fns to indicate that the
function switch states will not be changed with this preset.
Pdl (Expression Pedal)
Press the ► switch to display the expression pedal MIDI Channel for this preset. Use
the +/- switches to edit the channel. The available options are OFF, Gbl, and 01
thru16. When set to OFF, the expression pedal is not active and pedal data is not sent
for this preset. When set to GBL, the global pedal channel assigned in Setup Mode will
be used (see Setup Mode- Expression Pedal Continuous Controller on page 19).
Press ► again to set the expression pedal MIDI Continuous Controller number. Use the
+/- switches to set the value.
23
Advertisement
Table of Contents
