kiwy SF01 Instruction Manual page 6

cars.
It must not be considered a house or table seat, nor a toy.
For a correct installation, follow the instructions given in this booklet,
with particular attention to the orientation of the child seat in the
vehicle based on the weight of the child.
What to do
Before installing the SF01 car seat in the vehicle, read these instructions
carefully, in case of an accident an improper installation can be
dangerous for the baby.
NOTE: If your vehicle is included in the list of compatible vehicles and is
equipped with Isofix anchor points, please install the child car seat using
the seat belt and Isofix connectors.
- Keep this booklet in a safe place, so you should keep it in the vehicle
for future reference at any time when necessary.
- After installing the child seat, check that no part of its harness belts or
seat belt of the vehicle remained stuck between the moving parts of the
child seat, the vehicle seat or in a door.
- Check each time you use the child seat, that it is securely locked in
place with the seat belt tight, not twisted and properly secured.
- Before starting a trip with the baby on board of the child seat, check
that the harness belts are properly adjusted and the buckle is properly
fastened.
- Exposure to the sun, even of short duration, can heat a lot the interior
of the car. To avoid overheating of the child seat, with the risk of causing
burns to the child, we recommend covering the seat with a fabric sheet,
a towel or something similar.
- Regularly check the child seat for signs of wear or malfunctions of any
kind , with particular attention to the harness belts, its buckle and the
fabric covers
- In case of malfunction or evident wear, discontinue using the seat and
4