kiwy SF01 Instruction Manual page 14

length that cannot be adjusted.
Place the child in the child seat and fasten the harness belts combining
the two tabs (Fig. 19) and inserting them into the buckle until you hear
a 'click' , which confirms they're correctly fastened (Fig. 20).
Place the harness straps as indicated in Fig. 21, on the shoulders (a) and
the pelvis (b), and the buckle (c) between the child's legs.
Pulling the frontal adjustment belt (part "C"), tighten the straps making
them adherent to the child's body.
NOTE: Too much tension can be fastidious for the child with the risk
that the latter attempts to get rid of it.
For this reason, the adjustment of the belts must simply eliminate any
excessive slack.
Installation instructions in the vehicle travel direction (9 to
18 kg)
The SF01 seat can accommodate children forward facing as early as
they weigh 9 kg.
For children weighing more than 13 kg, the child seat MUST be turned
in the travel direction and on a compatible seat of the vehicle, as
indicated in its user manual.
In this condition, the retractable spacer MUST be rotated in the position
shown in Fig. 27.
NOTE: The rotation of the retractable spacer is possible only when
the seat is adjusted to its maximum reclined position.
IMPORTANT: When installing the seat in the travel direction, please do
NOT use the retractable spacer rotated forward. An excessive lying
position may be dangerous to the child, in the event of an accident.
- Place the child restraint on the appropriate seat of the vehicle in the
travel direction.
- Please check the vehicle's seat headrest is not in the way for a proper
12