Connect Dh-485 Devices To The Interface Converter's Rs-232 Port - Allen-Bradley 1747-UIC Installation Instructions Manual

6 Universal Serial Bus (USB) to DH-485 Interface Converter

Connect DH-485 Devices to the Interface Converter's RS-232 Port

Personal
Computer with
USB Port
AIC+
ControlLogix
Controller
Connect the Following DH-485 Equipment to the RS-232 Port
SLC 5/03, SLC 5/04, and SLC 5/05 (Channel 0)
1761-NET-AIC (AIC+) Advanced Interface Converter
PanelView 300 and higher Terminals with RS-232 (DH-485) Ports
(1)
MicroLogix Controllers
PanelView 300 Micro (DH-485) Terminals
(1)
CompactLogix Controllers
(1)
FlexLogix Controllers
(1)
ControlLogix Controllers
(1)
Make sure your controller's Channel 0 configuration is set to DH-485 prior to connecting the 1747-UIC interface converter to
Channel 0. The factory default is DF1.
ATTENTION
Publication 1747-IN063C-EN-P - January 2006
PanelView 300 and higher Terminal
USB (DF1)
CAT SER FRN
1747-UIC A X.X
USB
USB to DH485 OK
INTERFACE CONVERTER
DH485
1747-UIC
LISTED I.T.E.
RS485 (DH485)
SW
Mfg
XXXX
N223
RS232 (DH485)
To avoid ESD damage to the interface converter, always connect
the interface converter to the properly grounded DH-485 device
or interface prior to plugging the USB cable into the computer's
USB port.
(1)
Controllers
SLC 5/03, SLC 5/04, and
SLC 5/05 (Channel 0) Controller
CompactLogix Controller
FlexLogix Controller
MicroLogix
Controller
Use Cable
1747-CP3, 1756-CP3
1747-CP3, 1756-CP3 (Port 1, 9-pin D)
1761-CBL-PM02 (Port 2, 8-pin DIN)
2711-NC13 or equivalent
1761-CBL-PM02 or equivalent
1747-CP3, 1756-CP3
1747-CP3, 1756-CP3
1747-CP3, 1756-CP3