Table of Contents
Advertisement
Install the Module
To install your module into the chassis:
1. Turn off the chassis power supply.
WARNING
!
2. Align the circuit board of the thermocouple module with the card guides located at
the top and bottom of the chassis.
3. Slide the module into the chassis until both top and bottom retaining clips are
secured. Apply firm even pressure on the module to attach it to its backplane
connector. Never force the module into the slot.
4. Cover unused slots with the card slot filler, catalog number 1746–N2.
If you insert or remove the module while backplane power is on, an
electrical arc can occur. This could cause an explosion in hazardous
location installations. Be sure that power is removed or the area is
nonhazardous before proceeding.
Barrel Temperature Control Module
Publication 1746-IN020B-EN-P - July 2002
5
Advertisement
Table of Contents
