Table of Contents
Advertisement
• Power Saving Mode
saving menu item lets you reduce power usage
when the printer is idle.
Press 1 to turn the feature ON. The display asks
you to determine the length of time the printer
waits after a job is printed before i t g o e s t o a
r educed power state:
P ress 1 for 10 minutes, 2 for 15 minutes, 3 for 30
minutes, 4 for 45 minutes, or 5 for 60 minutes.
If your printer is used constantly, p re s s 2 t o t u r n
the feature OFF. I t k e e p s t h e p r i n t e r ready to print
with the minimum warm-up time.
• ECM Mode (Error Correction Mode)-This mode
compensates for poor line quality and ensure s
accurate, erro r- f ree transmission with any other
ECM-equipped facsimile machine. If the line
quality is poor, transmission time may be
i n c reased when ECM is enabled.
Press 1 to turn the Error Correction mode on.
Press 2 to turn the Error Correction mode off .
• RX Reduction-When receiving a document as
long as or longer than the paper installed in your
machine, the machine can reduce the data in the
document to fit into your recording paper size.
Turn on this feature if you want to reduce an
incoming page that may otherwise need to be
divided into two pages with only a few
centimeters on the second page. If the fax machine
cannot reduce the data to fit into one page with
the feature enabled, the data is divided and
printed in actual size on two or more s h e e t s i f
needed.
P re s s 1 t o t u r n t h i s f e a t u re on. Note that this
feature does not apply to the copy mode.
P re s s 2 t o t u r n t h i s f e a t u re o ff. The overflow data
will be printed out on a second page.
Samsung Electronics
(SF-5800P only) - The power
• H.(Horizontal) Reduction-If you turn the RX
r eduction feature on, you are allowed to set the
horizontal reduction feature o n o r o ff. When you
set the horizontal reduction to be on, the machine
w i l l reduce an incoming page containing overflow
data only in vertical as shown below.
If you want to reduce both in vertical and horizontal
at the same rate in order to maintain height to width
r elationships, turn the horizontal reduction feature
o ff . I f y o u t u r n o ff t h i s f e a t u re, the machine reduces
the data as shown below.
P re s s 1 t o t u r n t h i s f e a t u re o n .
P re s s 2 t o t u r n t h i s f e a t u re o ff .
• Discard Size-When receiving or copying a
document as long as or longer than the paper
installed in your fax machine, you can set the fax
machine to discard any excess image at the
bottom of the page to fit into the recording paper
s i z e .
I f t h e received page is outside the margin you set,
it will be printed on two sheets of paper at the
a c t u a l s i z e .
If the data is within the margin, and the Auto
Reduction feature i s t u r n e d o n , i t w i l l b e reduced
t o f i t i n t o t h e a p p ropriate size paper (Discard does
n o t t a k e p l a c e ) . I f t h e Auto Reduction feature i s
turned OFF or fails, the data within the margin
will be discarded.
Enter the desired discard size using the number
keypad, and press Enter.
Setup and Installing
3-21
Advertisement
Table of Contents
