Fujitsu PRIMERGY RX100 S5 Operating Manual page 50

Installing/removing the server in/from the rack
Figure 7: Inserting the server
Ê Push the prepared server into the rails that are attached to the rack until the
server rails engage (1).
I
Ensure that the server is inserted horizontally and is not tilted.
Ê Press the safety springs in on both sides (2).
Ê Gently push the server as far as it will go into the rack (3).
Ê Fasten the server to the rack (4) using the two knurled screws (front panel).
To remove the server, follow this procedure in reverse.
50
1
2
Operating manual
Hardware installation
1
3
4
4
RX100 S5