Table of Contents
Advertisement
3.6
Connecting the Power Supply
Before connecting the power
Connecting Procedure
3-10
Follow the warnings below to avoid electric shock and damage to the instrument.
• Connect the power cord only after confirming that the voltage of the power
supply matches the rated electric power voltage for the instrument.
• Connect the power cord after checking that the power switch of the instrument is
turned OFF.
• To prevent electric shock or fire, always use the power cord supplied by
YOKOGAWA.
• Always use protective earth to prevent electric shock. Connect the power cord
of the instrument to a three-pole power outlet that has a protective earth
terminal.
• Never use an extension cord that does not have protective earth, otherwise the
protection function will be compromised.
1.
Check that the power switch is OFF.
2.
Connect the plug of the accessory power cord to the power connector on the
rear panel of the instrument.
3.
Plug the other end of the power cord into a power outlet that satisfies the
conditions below. The AC outlet must be a three-pole type that has a protective
earth terminal.
Item
Rated supply voltage
Permitted supply voltage range
Rated supply voltage frequency
Permitted supply voltage frequency range
Maximum power consumption (when using the printer) : 200 VA
3-pin outlet
WARNING
: 100 to 120 VAC, 200 to 240 VAC
: 90 to 132 VAC, 180 to 264 VAC
: 50/60 Hz
: 48 to 63 Hz
On some instruments,
the direction of the power
connector may be as shown below.
Power cord (included in the package)
Specification
IM 253710-01E
Advertisement
Table of Contents
