La Crosse Technology WT-3161 Faq page 4

 Opening the clock voids the warranty.
WHY DO THE HANDS SPIN ONCE OR TWICE EVERYD AY?
 When the hands spin about the same time every day the clock is auto-correcting the
time. The hour hand should not spin more than twice around the clock.
 Hands may spin if the battery is underpowered or over powered.
 Use only Alkaline batteries in the clock.
HANDS SPIN NON-STOP
 This is indicative of a low or overpowered battery (number 1 warranty issue).
 Replace battery and perform restart procedure. Allow 5 days to catch the WWVB signal
 If constant spinning continues, the movement may need replacement.
HANDS JUMPS OR JERKS AROUND THE DIAL
 This is indicative of a low or overpowered battery (number 1 warranty issue).
 Replace battery and perform the
signal.
 If the hands continue to jump, the movement may need replacement.
HANDS STUCK AT CERTAIN TIME
 This is indicative of a low or overpowered battery (number 1 warranty issue).
 Replace battery and perform restart procedure. Allow up to 5 days to receive a signal.
 Check to see if the hands may be bent.
 Movement may need replacement.
HANDS ARE LOOSE.
 If under warranty, the clock must be sent in for repair or the movement needs to be
replaced.
POSITION THE CLOCK
 This La Crosse Technology
 INDOOR: Select a location to place the radio-controlled clock where it will be at least
six feet away from a TV, computer, air conditioner or other household electrical
appliances. The optimal location is near a window. Windows facing Colorado provide the
best signal.
La Crosse Technology, Ltd
restart procedure. Allow up to 5 days to receive a
® atomic clock is designed for indoor or outdoor use.
Page 4