La Crosse Technology WT-3161WH Manual
16” atomic wall clock
Hide thumbs
Also See for WT-3161WH:
- Instruction manual (4 pages) ,
- Instruction manual (4 pages) ,
- User manual
Advertisement
Quick Links
16" Atomic Wall Clock
Model: WT-3161WH
DC: 062617
Power up
1.
Select Time Zone and DST ON or OFF.
2.
Insert 1 AA battery into the movement.
3.
For best reception, place clock on a wall that
faces Ft. Collins, Colorado.
4.
During the night, your clock will set itself.
IMPORTANT:
• Hands will move to 12:00 and search for the
atomic time signal.
• If no signal, after 8-10 minutes, clock will run
from 12:00 am.
• Clock will continue to search for the WWVB
atomic time signal.
• Allow up to 5 nights for the clock to receive
the atomic time signal.
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for La Crosse Technology WT-3161WH
Summary of Contents for La Crosse Technology WT-3161WH
- Page 1 • If no signal, after 8-10 minutes, clock will run from 12:00 am. • Clock will continue to search for the WWVB atomic time signal. • Allow up to 5 nights for the clock to receive the atomic time signal. Model: WT-3161WH DC: 062617...
- Page 2 Care and Maintenance • Always purchase the correct size and grade of battery most suitable for use. • Clean the battery contacts and also those of the device prior to battery WAVE (Atomic search) installation. • Ensure the battery is installed with correct polarity (+ and -). RESET •...
Need help?
Do you have a question about the WT-3161WH and is the answer not in the manual?
Questions and answers
I can’t get my clock to reset after changing the battery.
To reset the La Crosse Technology WT-3161WH clock after changing the battery:
1. Remove the battery.
2. Press the Time Set tab 20 times to clear the electrical charge.
3. Wait for 15 minutes.
4. Install a fresh, new battery.
5. Allow the clock hands to spin to the 12:00 position so it can search for the atomic signal.
If needed, you can manually set the time by holding the Set button for 3 seconds. The atomic time signal will override manual settings when connected.
This answer is automatically generated