Entering The Stitch Length; Entering The Standard Stitch Length; Entering A Second Stitch Length Or Amount Of Fullness - Pfaff 1571 Instruction Manual

9

Entering the stitch length

.08
The stitch length is set by adjusting the feed strokes of the roller presser and the feed
wheel. For the application of fullness, the feed stroke of the roller presser must be larger or
smaller than the feed stroke of the feed wheel.
9

Entering the standard stitch length

.08.01
Switch on the machine.
After the machine has been switched on the current values of the stitch lengths for roller
presser and feed wheel are displayed.
Adjust the stitch length (feed stroke) for the roller presser by pressing the corresponding
+/- key.
Adjust the stitch length (feed stroke) for the feed wheel by pressing the corresponding +/-
key.
9

Entering a second stitch length or amount of fullness

.08.02
With the use of the PM key, a second stitch length or fullness setting can be set in addition
to the standard stitch length. By operating the knee switch it is possible to switch from one
setting to the other in the programmed sewing mode.
Switch on the machine.
Press the PM key to move into the programmed sewing mode.(LED lights up)
Select the program number (1 or 2) by pressing the corresponding +/- key.
Sew 1 – 2 stitches and operate the knee switch, also see Chapter 7.05 Knee switch.
Set the stitch length (feed stroke) for the roller presser by pressing the corresponding +/-
key.
Set the stitch length (feed stroke) for the feed wheel by pressing the corresponding +/-
key.
2.5 2.5
2
1 1 2.5 2.5
Setting up
43