Installing The Pen Carriage - US Cutter MH-721 Manual

Make sure that your Baud Rate option is set to 9600.
Do not change the, Data Bits, Stop Bits, or Parity options.
Make sure the Flow Control option is set to "Hardware".

Installing the Pen Carriage

Most new users will benefit from practice "cutting" with the supplied pen carriage until they are comfortable with
normal operations of the cutter and cutting software.
Your Pen Carriage should come assembled and appear as it does in this image. If it does not, please refer to the pen
replacement section below for assembly instructions.
To install the pen carriage:
Loosen the locking knob on
the carriage arm.
Drop the pen attachment into
place in the front slot of the
carriage arm.
Tighten the locking knob on
the carriage arm.
- 15 -