US Cutter MH-721 Manual page 24

Now press the Origin button to tell the cutter that this is the location where you would like the cut to
begin.
When choosing a starting location for your design, remember that the process will start in the bottom right area of the
design. Please leave enough room to the left of and behind the starting location to finish your cut.
If you would like to make other adjustments to the pressure, speed, or other settings you can do so now. If you are setting
up for your first cut with the machine then the default values should be a good starting point.
If you make any adjustments to your cutter, make sure that you return to the main screen before you attempt to cut. If
you are unsure how to do this, refer to the Control Panel section of the manual on page 8.
- 23 -