5.16 Drive Ass'y
1. Before you remove the Drive Ass'y, you should
remove:
- Rear Cover (see page 5-2)
- Side Cover (LH) (see page 5-3)
- Shield Controller Ass'y (see page 5-9)
2. Remove the 5 screws securing the Drive Ass'y.
Drive Ass y
5.17 Cover Mid Front
1. Before you remove the Cover Mid Front, you should
remove:
- Rear Cover (see page 5-2)
- Side Cover (LH, RH) (see page 5-3)
- Middle Cover (see page 5-14)
Samsung Electronics
3. Take out the Drive Ass'y, then unplug the connector
from the Motor PBA, as shown below.
Drive Ass y
Caution. The six screws have numbers stamped. into
the Drive Ass'y base plate. When refitting the
Drive Ass'y tighten the screws the order they
are numbered. Only screw s numbered 1 to 5
are fitted at this stage. Screw 6 is fitted when
the Shield Controller Ass'y is refitted
2. Remove the 4 screws securing the Cover Mid Front
and release 2 clips in the center. This cover is fragile
take care when removing it.
clips
Cover Mid Front
Precautions
Service Manual
5-21