Table of Contents
Advertisement
12
en | Installing a Recessed Mount
4.
Figure 4.7 Attach Camera to Recess Mount
NOTICE!
The recessed mounting bracket is provided with an additional
safety tether point. To prevent injury, attach a safety wire from
a secure anchor point above the ceiling to this tether point.
5.
F.01U.261.808 | 1.0 | 2011.10
camera), and attaching the camera base to the mount
using 4 M4 mounting screws with rubber ring (supplied
with the camera). Ensure that the cable is aligned with the
cutout in the recess mount.
Attach the camera base and make the necessary DIP
switch settings, and then install the bubble. (See the
camera User Manual for details.)
Align the trim ring so that the three alignment poles on the
trim ring (item 1, below) align with the three mounting
holes in the camera. Align the two mounting screws
attached to the trim ring (item 2, below) with the two
mounting holes in the recess mount.
Installation Manual
Mini PTZ Dome Accessories
Bosch Security Systems, Inc.
Advertisement
Table of Contents
