g Place the system in a 90° position on the edge of a plane surface with the display facing down.
h Remove the 6 (M2.5x5) display hinge bracket screws that secure the display assembly to the system [1].
i
Lift the display assembly away from the system [2].
Installing display assembly
1
Place the chassis on the edge of a plane surface.
2
Align the display assembly with the screw holders on the system.
3
Replace the 6 display hinge bracket screws to secure the display assembly to the system.
4
Lift the system and close the display.
5
Connect the eDP cable to the connector on the system board.
6
Affix the adhesive tape to secure the eDP cable to the system.
7
Place the eDP metal bracket to secure the eDP cable.
8
Replace the single screw to secure the eDP bracket to the system.
9
Install the:
a
battery
b
base cover
c
microSD card
10
Follow the procedure in
After working inside your
computer.
Removing and installing components
31