Lincoln 83167 Installation Instructions

LUBRICANT OUTPUT
RATIO
(cu. in.)
PER PER MIN.
CYCLE (@100PSI)
*.11 12
40:1
TYPICAL
INSTALLATION
The 83167 Pump is used as
pumping unit for a centralized
lubrication system having a single
line circuit of SL-1, SLS-11, SL-32,
OR SL-33 Injectors.
It is an air operated reciprocating
pump that discharges an established
amount of lubricant *(.11 cu. in.) into
the circuit for each pump cycle.
*Based on lubricants that are free
of entrapped air. Lubricants that are
aerated will reduce output of pump.
FILL RESERVOIR
Use 81834 Manual Filler Pump to fill reservoir through the filler
fitting in the pump body. Attach coupler on delivery hose to filler.
Stroke filler pump handle until lubricant weepage is noted at air
vent hole in reservoir (lower portion of follower must rise beyond
air vent hole to expel entrapped air from lubricant).
NOTE: When filling the reservoir, caution should be used as extreme
pressure can cause damage to reservoir and follower assembly.
JULY - 2005
AIR OPERATED GREASE PUMP
RESERVOIR AIR LUBRICANT
CAPACITY INLET OUTLET
1/8"
12 LBS.
NPTF(F)
the
One Lincoln Way
St. Louis, Missouri 63120-1578
(314) 679-4200
LUBRICANT OPERATING PRESSURE (PSI)
TYPE OF
MINIMUM
SYSTEM
SL-1
3/4" SL-11
NPTF(F) SL-32
SL-33
Copyright 2005
Printed in U.S.A.
Model No. 83167
Series "H"
RECOM-
MAXIMUM
MENDED
1,850 3,550
1,200 3,550
Section
- 85T
Page
FORM 403574
2,500
1,500
- C8