Connection To An External Monitor; Connecting Speakers - RCA PHD42600 User Manual

Connection to an external monitor

This monitor is able to output video signal to an external monitor or other component from the
RGB OUT jack. Connect one end of a 15-pin monitor cable to the external monitor or
component and the other end to the RGB OUT jack on the back of the monitor. Then connect
the Audio OUT jacks (L and R) on the monitor to the Audio In jacks on the back of your
external monitor.
Note: A video signal will not be ouput from the RGB OUT jack when the main power of
this unit is off or in standby.

Connecting speakers

Before making connections, be sure to check that the audio component's power and the unit's
main power is off. Speaker cords, 1 for each speaker, are needed for connection. Twist the
stripped ends of speaker cord about 2/3 inch (15 mm). Press down on the tab to open the
terminal and insert the wire. Let go to close the tab.
Note: When making speaker connections, be sure to match the polarities (+ and –) of the
speaker terminals on this unit and the corresponding terminals on the speakers. If the
polarity is reversed, the sound will be unnatural and lack bass.
Chapter 1
RGB OUT
To an external monitor
Twist exposed wire
strands together.
Push tab to the open
position, and insert the
wire. Then, let go of the
tab to secure the wire
in place.
Graphics contained within this publication are for representation only.
Connections and Setup
11