Turnigy 9XR User Manual page 26

it's use would be using it as a LAND function, cut the throttle, flip the switch, and use the elevator
trim to set a good glide angle.
5. Trim: When this is "ON" the trim value (if exists) will be carried on through the mix. When"OFF"
it is ignored.
6. Curves:
i. x>0: The value of the source is carried through only if it is positive (greater than zero).
Otherwise it is zero.
ii. x<0: Same but for negative values.
iii. |x|: The value is passed as an absolute value.
iv. f>0: If source is positive then the output value is "+weight" otherwise it is 0.
v. f<0: If source is negative then the output value is "-weight" otherwise it is 0.
vii. c1..c16: custom curves. These are defined in the "CURVES (6/8)" screen. You can also
press [MENU] to edit the curve directly.
7. Switch: Here you select the switch that operates the mix.
If the switch is not selected then the mix is on by default.
8. Warning: Here you can select an audible warning that will sound whenever a mix is active.
(This will only work when a switch is defined). You have an option of 1, 2 or 3 beeps. The
warnings will sound in succession so you can hear them individually.
9. Multpx: This value defines how the mix will be added to the channel.
i. Add: This is the default value. With this value the mix is added to the previous values in
the same channel.
ii. Multiply: Use this to multiply the previous values in the same channel.
iii. Replace: This value is used in conjunction with a switch. When the switch is off the value
is ignored. When the switch is on the value discards the previous values and places
it's own value in the channel.
10. Delay Down/Up: Use this to delay use of this channel. Usually used with a switch.
When the switch is turned "ON" or "OFF" the mixer will wait the specified number of
seconds before changing the value.
11. Slow Down/Up: Slow the rate of change in the channel.
When not zero these will determine the maximum speed with which the value can change.
The specified value is the number of seconds to go between -100% to 100%.
12. DELETE MIX [MENU]: Pressing [MENU LONG] here will delete the mix and return to the main
mix screen.