Trainer - Turnigy 9XR User Manual

Trainer (2/5)

TRAINER
mode % src sw
RUD := 100 ch4 TRN
THR := 100 ch3 TRN
ELE := 100 ch2 TRN
AIL := 100 ch1 TRN
Multiplier 1.0
This menu allows the PPMin (trainer) inputs to be configured. It enables the RAW PPM inputs to be
selected to replace the sticks for training purposes. The student transmitter does not need to have
the same model setup as the instructor. All the mixes on the instructors Tx will be applied to the
student inputs. If, for example, you have expo on your sticks, this will be applied to the raw trainer
inputs when they are selected.
The mode entry selects how the PPMin value is used:
Off unused
+= add to instructor stick value
:= replace instructor stick value
The % entry applies a weighting to the PPMin value -100 to 100, Use -100 to reverse the input. Use
values closer to 0 to reduce the students control sensitivity.
The src entry selects the PPMin channel for the function.
The sw entry selects the switch used to action the trainer operation.
Multiplier 1,0 to 5,0 scale for PPMin values
The multiplier does as it's name suggests. It multiplies the ppm Input by a set amount. Great for
dealing with different tx's whose makers don't know how to encode PPM :-P.
CAL Center calibration for first 4 PPMin values
This entry allows you to calibrate the mid point for the first 4 input PPM channels.
Highlighting "Cal" and pressing [MENU] will calibrate the mid point for all PPM IN channels.
PPM IN is read from the signal at the trainer port of the Tx.
There is an option for each model to enable or disable the trainer input function. If you do not
need the trainer function you may disable it, and use the selected switch for something else. All
the PPMin values are available to the mixer.
2/5