OPERATION INSTRUCTIONS SYSTEM DESCRIPTION MODES OF OPERATION, FUNCTIONS AND FEATURES USE OF WIRELESS REMOTE CONTROL CENTRAL CONTROL DISPLAY PANEL REMOTE CONTROL OPERATION PROCEDURE TIME OPERATING MODES PROTECTION MODES CARE AND MAINTENANCE OPERATING TIPS BEFORE CALLING FOR SERVICE...
OPERATION INSTRUCTIONS SYSTEM DESCRIPTION 1.Power Supply 2.Return Air Intake 3.Supply Air Outlet 4.Central Control Unit Cord 5.Central Control Unit Display 6.Interconnecting Cable 7.Condensate Tube 8.Suction Tube 9.Liquid Tube 10.Outdoor Unit Air Intake 11.Outdoor Unit Air Outlet 12.Remote Control Unit 13.Remote Control Holder...
CENTRAL CONTROL DISPLAY PANEL A. STAND-BY INDICATOR Lights up when the air conditioner is connected to power and ready to receive the remote control commands. B. OPERATION INDICATOR Lights up during operation. Blinks to announce that the remote control infrared signal has been received and stored.
CARE AND MAINTENANCE CAUTION Before performing any maintenance procedure ,make sure to disconnect the air conditioner from the power supply. CLEANING THE CONTROL UNIT Wipe off the control unit with a dry soft cloth. Avoid using hot water or volatile materials which could damage the surface. AT THE BEGINNING OF THE SEASON Make sure no obstacles exist that block the flow of inlet or outlet air of the outdoor unit.
BEFORE CALLING FOR SERVICE Before calling for service, please check the following malfunctions and correct as needed. PROBLEM CAUSE REMEDY Unit does not operate. Unit not connected to power. Set the power supply switch to ON. operation indicator does not light up.
Page 19
INSTALLATION GENERAL UNIT LOCATION CRITERIA INDOOR INSTALLATION Indoor Unit Location Floor Mounting Ceiling Mounting OUTDOOR UNIT INSTALLATION INSTALLATION OF INTERCONNECTING TUBING BETWEEN INDOOR AND OUTDOOR UNITS General Recommendation For Interconnection Tubing Installation Setting in Operation flare preparation connecting the tubes evacuation and setting in operation DRAIN LINE INSTALLATION ELECTRICAL CONNECTIONS...
Page 21
. Air Supply . Electrical Box . Access Panel . Refrigeration Tubing Port . Drain Port - G (OD) . Control Unit Port . Main Power Port . RETURN AIR ( 866 x 325 x 18 ) 65.5...
Page 30
Use supply wire sizes as per local electrical codes and regulations...
Page 31
Clock Single phase units power to Indoor Unit Circuit Breaker Model Maximum Current (without Heating Element) GC-16-RCF GC-18-RCF Use supply wire sizes as per local electrical codes and regulations. Figure 18a. Single Phase Units: Electrical Scheme power supply to indoor Clock Single Phase units Power to Indoor Unit Circuit Breaker...
Need help?
Do you have a question about the DS48RCF and is the answer not in the manual?
Questions and answers