Switch Replacement / Door Adjustment - Amana CRC18T2OG Service Manual

Disassembly
!

Switch Replacement / Door Adjustment

!
To avoid risk of electrical shock, personal injury or
death; disconnect electrical power before servicing.
1. Remove and retain two (2) screws securing switch to
cavity. Remove switch.
2. Position new switch assembly into cavity opening.
• First, insert bottom ramp of switch into bottom
opening.
• Tilt switch upward and insert top ramp of switch
into top opening.
• Be sure both ramps are fully protuded through the
front frame of cavity.
Cavity
Front
3. Loosely install screws removed in step 1.
4. Push and hold switch assembly towards front of oven
and tighten screws.
5. Transfer wires to new switch.
6. Install wire ties as indicated. All wire ties must be
installed.
Important: It is necessary to adjust the door
assembly for correct switch function.
RS2240002 Rev. 1
WARNING
WARNING
To avoid the risk of electrical shock, personal injury, or
death, disconnect power to oven and discharge
capacitors before following any disassembly procedure.
7. Tape shims 12382602 and 12019302 to door, as
shown.
12019302
Shim
.030 in. \ .75 mm
.060 in. \ 1.5 mm
8. With door closed, loosen door hinge bolts 1/2 turn.
9. Lift upward on door, using the door handle.
10.With left hand, clamp door to cavity on hinge side of
door.
11. While holding door in place, tighten hinge bolts in the
order shown.
12.Open and close door serveral times to check switch
operation.
Wire
ties
NOTE: If switches do not activate, check condition and
alignment of door and hinges.
13.Remove shims.
28
12382602
Shim
3
4
1
2