User Options - Amana CRC18T2OG Service Manual

Programming Instructions

User Options

Follow the instructions below to customized the
microwave oven's operation. End-of-cycle signal,
maximum cooking time and other options can be
changed to meeting your cooking needs. Example:
Change setting to single digit pad operation.
1. Open oven door.
• If door is closed or RESET pad is pressed before
finishing programming sequence, oven exits
programming mode.
2. Press and hold pad 2 for approximately 5 seconds.
• After 5 seconds, signal sounds. Display shows
"0P:".
Numbered Pads
1
End of Cycle Beep
2
Speaker Volume
3
Key Beep
4
Keyboard Enable
Window
5
Add Time during
Heating
6
Reset Door Open
7
Maximum Heating
Time
8
Manual Operation
9
Double Digit
Operation
RS2240002 Rev. 1
Display Options (Factory Settings in Bold)
OP:10 3 second continuous beep.
OP:11 Continuous beep until door is opened.
OP:12 5 beeps bursts until door is opened.
OP:20 Eliminates beep.
OP:21 Sets volume to low.
OP:22 Sets volume to medium.
OP:23 Sets volume to high.
OP:30 Prevents beep when pad is pressed.
Allows beep when pad is pressed.
OP:31
OP:40 15 seconds after oven door is opened, keyboard disabled.
OP:41 30 seconds after oven door is opened, keyboard disabled.
1 minute after oven door is opened, keyboard disabled.
OP:42
OP:43 2 minutes after oven door is opened, keyboard disabled.
OP:50 Prevents adding heating time while oven is heating.
OP:51 Allows heating time to be changed while oven is heating
when a memory pad is pressed.
OP:60 Allows oven to resume heating time countdown after door is
opened during cycle.
Cancels heating time countdown after door is opened during cycle.
OP:61
OP:70 Allows 60 minutes of heating time.
OP:71 Allows 10 minutes of heating time.
OP:80 Allows use of preprogrammed pads only.
OP:81 Allows use of manual time entry and preprogrammed pads.
Allows 10 (0-9) preprogrammed pads.
OP:90
OP:91 Allows 100 (00-99) preprogrammed pads.
3. Press 9 pad.
• See table for options.
• Displays shows "OP:91".
• "OP" represents optional program mode, first
number represents option number and second
number represents functions currently selected for
option.
4. Press 9 pad repeatedly to change setting.
5. Press START pad to save changes.
• Repeat steps 3-5 to change additional options.
• Changes appear after door is closed or STOP/
RESET is pressed.
6. Press STOP/RESET pad or close oven door to exit
programming mode.
16