Silvercrest 106635 Operating Instructions Manual page 21

5. To start the measurement, press on the "FOREHEAD"
button . The symbol
3
and the measurement will start after an acoustic
4
signal.
6. The end of the measurement is indicated by 2 acoustic
signals.
7. Now you can read off the measurement result on the
LC display
will come on.
Note: LED green
(93.2 °F - 99.4 °F)
LED orange
37.5 °C - 37.9 °C (99.5 °F - 100.3 °F) LED red fever
38.0 °C - 42.9 °C (100.4 °F - 109.2 °F)
5
8. Values can be displayed in °C as well as in °F
(see "Functions / error analysis - selecting the
temperature unit").
9. Repeat steps 3 to 6 to carry out further measurements.
Note: The appliance automatically switches off if it is not
operated for longer than 1 minute. When the sleep mode
has been activated, the LC display
When the sleep mode has been deactivated, the appliance
switches to standard mode. If the thermometer has been
operated under normal conditions, the result of the last
measurement taken before the appliance was switched off
is stored. The measured value is available again along
with information on the date, time and measurement mode
when the "MEM / SET" button
. At the same time, one of the 3 LEDs
4
no fever 34.0 °C - 37.4 °C
7
slight increase in temperature
6
will appear in the LC display
switches itself off .
4
is pressed again.
9
GB 21