Environmental Protection - Worx WX372 Original Instructions Manual

Tungsten carbide drill bits should
always be used for concrete and
masonry. when drilling in metal, only use
HSS drill bits in good condition. always
use a magnetic bit holder (not included)
when using short screwdriver bits. when
screw-driving, apply a small quantity
of liquid soap or similar to the screw
threads to ease insertion.
10. DISPOSaL OF aN EXHaUSTED
BaTTERy PaCK
To preserve natural resources, please
recycle or dispose of the battery pack
properly. This battery pack contains
Li
Lithium batteries. Consult your local waste
authority for information regarding available
recycling and/or disposal options. Discharge
your battery pack by operating your drill, then
remove the battery pack from the drill housing
and cover the battery pack connections with
heavy-duty adhesive tape to prevent short
circuit and energy discharge. Do not attempt
to open or remove any of the components.
pROBLEM SOLUTION
1. wHy DOES THE DRILL NOT TURN ON
wHEN yOU PRESS THE SwITCH?
The forward and reverse switch, which is on
top of the trigger, is positioned in the lock
function. Unlock the forward and reverse
switch putting it into the required rotation
position. Push the trigger and the drill will
start to rotate (See Fig.B).
2. THE DRILL STOPS BEFORE THE
SCREw IS COMPLETELy TIgHTENED.
wHy?
Verify the torque position of the torque
adjustment ring, you can find the torque
adjustment ring between the chuck and the
drill body. Position 1 is the lowest torque
(screw driving force) and position 22 is the
highest torque (screw driving force). Position
is for drill operation. Regulate the torque
adjustment ring to a higher position to reach
the best result (See Fig.E).
Lithium-Ion cordless hammer drill
3. I CaN NOT FIT THE BaTTERy INTO
THE BaTTERy CHaRgER. wHy?
The battery can be inserted into the charger
only in one direction. Turn the battery around
until it can be inserted into the slot, the red
LED light should turn on when the battery is
charging.
4. REaSONS FOR DIFFERENT BaTTERy
PaCK wORKINg TIMES
Charging time problems, as above, and
having not used a battery pack for a prolonged
time will reduce the battery pack working time.
This can be corrected after several charge and
discharge operations by charging & working
with your drill. Heavy working conditions such
as large screws into hard wood will use up the
battery pack energy faster than lighter working
conditions. Do not re-charge your battery pack
below 0 C and above 30
o
performance.
MAINTENANCE
Remove the battery pack from the tool
before carrying out any adjustment,
servicing or maintenance.
Your power tool requires no additional
lubrication or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
ENVIRONMENTAL
pROTECTION
This product has been marked with a
symbol relating to removing electric
and electronic waste. This means that
this product shall not be discarded with
household waste but that it shall be returned
to a collection system which conforms to the
European Directive 2002/96/CE. It will then
C as this will affect
o
EN
11