Assembly - Gravely 915034 - ZT1640 Owner's/Operator's Manual

WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
TOOLS REQUIRED
• Adjustable wrench
• Petroleum jelly or dielectric grease.
UNPACK UNIT
Remove unit and all other components from
the shipping container. Engage transmission
bypass lever (see Moving The Unit Manually
on page 12). Push unit from container onto a
level surface. Disengage transmission bypass
lever.
FIRST TIME USE
1. Connect battery. See Battery Removal
and Installation on page 19 and perform
steps 2 and 3 in the installation section.
2. Place unit in operating position (figure 3):
a.Tip seat (item 2) back.
b. Secure seat (item 2) to unit with
clamping knob or nut (item 1) (located
in literature pack).
c.Install steering levers (item 3) on the
inside of the handlebar brackets with
mounting hardware (item 4).
d.Adjust steering levers (see Steering
Lever Adjustments on page 21).
3. Check oil (see Check Engine Oil in
Maintenance Schedule on page 13).
4. Check tire pressure (see Specifications
on page 26).
5. Fill fuel tanks (see Filling The Fuel Tanks
on page 11).
6. Adjust seat (see Seat Adjustment on
page 13).
7. Adjust mower lift pedal (see Mower Lift
Pedal Adjustment on page 11).
8. Check safety interlock system (see Safety
Interlock System on page 9).
9. Check function of all controls (see
Operation on page 9).
10. Check level and pitch of mower deck (see
Level and Adjust Pitch of Mower Deck on
page 17).

ASSEMBLY

2
2
1. Clamping Knob
or Nut
2. Seat
GB - 8
Shipping
Position
Operating
Position
4
3. Steering Lever
4. Mounting
Hardware
Figure 3
1
3
OE1010