Using The Proper Batteries; Removing/Installing Batteries - Invacare Pronto M41 Service Manual

SECTION 10—BATTERIES
NOTE: If there is battery acid in the bottom of the battery tray or on the sides of the battery, apply
baking soda to these areas to neutralize the battery acid. Before reinstalling the existing or new
battery, clean the baking soda from the battery tray or battery being sure to avoid contact with skin
and eyes. Determine source of contamination. NEVER install/reinstall a battery with a cracked or
otherwise damaged case.

Using the Proper Batteries

NOTE: For this procedure, refer to FIGURE 10.1.
1. Place battery on ground/flat surface.
2. Visually draw a horizontal and vertical centerline through the middle of battery.
3. Position the battery so that the terminals are above the horizontal centerline.
4. Visually inspect the battery to ensure the correct position of the POSITIVE and
NEGATIVE terminals.
Batteries with terminal configuration as shown below MUST be used. Batteries that
have the reverse terminal configuration MUST NOT be used - otherwise injury and
damage may occur.
Use This Configuration
U1 Battery

Removing/Installing Batteries

ALWAYS use the battery handle when lifting the battery. It is the most convenient
method and assures that the battery acid will not spill. It also helps to prolong the
life of the battery.
DO NOT tip the batteries. Keep the batteries in an upright position.
®
Pronto M41
WARNING
NEGATIVE (-)
Battery Terminal
NEGATIVE (-)
Battery Terminal
POSITIVE (+)
Battery Terminal
FIGURE 10.1 Using the Proper Batteries
WARNING
60
DO NOT Use
POSITIVE (+)
Battery Terminal
U1 Battery
Part No 1145724