Applying Power To The Drive; Start, Stop, Direction And Speed Control - Allen-Bradley 22C-B012N103 User Manual

Chapter 2 Start Up
46
5. Verify that the Stop input is present or the drive will not start.
IMPORTANT If I/O Terminal 01 is used as a stop input, the jumper between I/O Terminals
01 and 11 must be removed.
6. Verify that the Analog I/O DIP Switches are set to 10 volts.

Applying Power to the Drive

7. Apply AC power and control voltages to the drive.
8. . 8. Familiarize yourself with the integral keypad features (see
before setting any Program Group parameters.

Start, Stop, Direction and Speed Control

Factory default parameter values allow the drive to be controlled from the
integral keypad. No programming is required to start, stop, and control speed
directly from the integral keypad.
If a fault appears on power up, refer to
explanation of the fault code.
Rockwell Automation Publication 22C-UM001J-EN-E - January 2017
Fault Descriptions on page 115
page 47)
for an