TERK Technologies RMTHINTV1A Owner's Manual page 10

Setting Up the THINTV1A
(continued)
To mount the antenna using the mounting strips:
9
1. Clean the surface of the location with isopropyl
rubbing alcohol. Wipe gently, then let the area dry.
IMPORTANT: Do not use household cleaners.
2. While the area is drying, separate the mounting
strips. Snap them apart length-wise first, then
snap each of the resulting strips in half.
3. Remove the red liner. Press the adhesive strip
onto one of the top corners of the back of the
antenna. Repeat for the other top corner. Then
place a single mounting strip on the metal section
in the bottom middle of the antenna, with the strip
facing down.