Advertisement
ADJUSTMENTS
Adjustments of horizontal zero (0) balance and stylus pressure
If your cartridge has a detachable stylus protector, remove it and be careful not to touch
the stylus tip.
Release the arm clamp and lift the tone arm from the arm rest.
Turn the counterweight clockwise or counter-clockwise until the tone arm is balanced
horizontally as floating freely. During adjusting the horizontal zero (0) balance, be
careful that the stylus tip does not contact the turntable mat or turntable base.
After the tone arm is horizontally zero (0) balanced temporarily, place the tone arm on
the arm rest and lock it with the arm clamp.
While rotating the stylus-pressure ring, hold the counterweight steady with one hand
until 0 on the ring aligns with center line on the tone arm rear shaft. Now the
adjustment of the horizontal zero (0) balance should be complete.
After adjusting the horizontal zero (0) balance, turn the balanced counterweight
counter-clockwise to get the proper stylus pressure as the cartridge manufacturer s
recommendation when it meets center line on the tone arm rear shaft.
Adjustment of anti-skating control
Set the anti-skate control to a position which corresponds to the adjust tracking force. If the
cartridge tracking force is 2 grams, the anti-skate control should also be set to 2.
Adjustment of the platter speed.
Set the arm lift lever to the up position.
Set the speed select switch to 33
Press start button, platter start revolving. Release the arm clip and tone arm toward the
turntable platter.
Observe the appropriate strip of strobe calibration dots from the strobe lens. The lower
strip is for 60HZ power supply. The upper one is for 50 Hz.
If the strobe dots appear to flow to the right which means the platter is revolving slower
than rated speed, turn the pitch control knob in + direction until the strobe dots so
appear to flow to the left which means the platter is revolving faster than rated speed,
turn the pitch control knob, in
stationary.
After the platter speed has been adjusted correctly return the torn arm to the arm rest and
fix the arm clip.
direction until the strobe dots do appear to be
PAGE 6
Advertisement
