Checklist of Parts:
Turntable unit
Turntable platter
Turntable mat
45 RPM adapter
Counter weight
Headshell
ASSEMBLY AND SET-UP
Installation of turntable platter
Set the turntable base on a flat level surface. After checking to make sure all packing
materials have been removed, carefully place the platter on the center spindle. Then put the
mat on the platter.
Installation of cartridge
While installing a cartridge, refer to the instructions of that cartridge.
During installation, attach the stylus protector to guard the stylus tip from damage.
Connect the lead wires to the cartridge terminals. The terminals of most cartridges are
color coded. Connect each lead wire to the terminal of the same color.
White ( L
)------------------------Left channel
Blue ( L
)--------------------------Left channel
Red ( R
)--------------------------Right channel
Green ( R
)------------------------Right channel
Install a cartridge to the headshell, and tighten it with screws provided with the
cartridge.
Installation of headshell
Insert the headshell into the front end of the tubular tone arm.
Turn the locking nut counter-clockwise while the head shell firmly held horizontally.
Installation of counter weight
Slide counter weight onto the rear of the tone arm.
Twist the counter weight counter-clockwise and it will screw onto the rear of the tone
arm.
PLACEMENT
Place the turntable on a flat surface.
Locate the turntable as far away from the speakers as possible and isolate the unit from
sound radiation from them.
. 1
.
1
. 1
..1
... .1
1
PAGE 4