Vision PRO User Manual page 10

# 6 – If Pan/Tilt is selected choose the type of protocol that your camera uses. If you have any questions
about what Pan/Tilt units will work with your DVR contact your dealer. See Appendix C for connection
diagrams and a list of camera protocols that are available.
# 7 – Sensor Setup – Place a check in the box for each sensor input channel that you would like to be
activated.
# 8 – Type Of Sensor – The system defaults to a NC (Normally Closed Sensor Type) if your sensor is NO
(Normally Open Sensor Type) click on the box to change the type.
# 9 – Use Alarm – Not use Alarm – Select if you would like the system to sound a beep if one of the active
sensors are activated.
#10 – Recording Time by Sensor – Enter the designed recording time upon sensor activation.
# 11 – Control Setup – Place a check mark in the box for each control relay that you wish to activate.
# 12 – Name – You can give each control relay output a unique name. The name can be up to 14
characters long.
# 13 – Auto ON/OFF – You can assign the time that you would like the relay to turn on in the first row, and
the time you would like the relay to turn off in the second row.
# 14 – Sensor – If you would like the control relay to activate with a sensor input, enter the sensor number in
the box.
# 15 – Working Sec – Enter the amount of time in seconds that the control relay will remain active. The
maximum time is 255 seconds, the default time is 0 seconds.
# 16 – External Monitor – The sections lets you select the cameras that you would like to be included in the
switched external NTSC monitor output. You will also have to select the amount of delay that you would like
to have the system wait before switching to the next selected camera.
#17 – Save – After making any changes you must remember to click on the save button. If save is not
pressed before closing, any changes you made will be lost.
# 18 – Close – Exits setup
10