KYMCO Mongoose 90 Service Manual page 92

5
. FUEL SYSTEM
DISASSEMBLY
Remove the two screws on the retaining ring
and then remove retaining ring.
Remove the washer and control shaft.
Remove the rubber gasket from the fuel
valve body.
INSPECTION
Inspect the fuel valve body for dirt and clog.
Clean if necessary.
Replace the rubber gasket with new ones if
they are damaged or deteriorated.
Replace the O-rings with new ones if they
are damaged or deteriorated.
ASSEMBLY
Reverse the "DISASSEMBLY" procedures.
Install rubber gasket, control shaft, washer
and retaining ring.
＊
• Aligning the tab on the control shaft
with the outlet duct in the fuel valve
body.
• Aligning the tab on the retaining ring
with the outlet duct in the fuel valve
body.
5-5
Screws
Retaining Ring
Rubber Gasket
Control Shaft
Tab
Outlet Duct
Control Shaft
Washer
Fuel Valve Body
O-ring
Tab
Outlet Duct