Transmission Oil - KYMCO Mongoose 90 Service Manual

3
. INSPECTION/ADJUSTMENT

TRANSMISSION OIL

TRANSMISSION OIL
MEASUREMENT
Place the machine on a level place.
Remove the oil filler bolt and check the oil
level. It should be up to the brim of the hole.
If the level is low, add oil to raise it to the
proper level.
Reinstall the oil filler bolt and tighten to
specification.
Torque: 18 N-m (1.8 kgf-m, 13 lbf-ft)
TRANSMISSION OIL REPLACEMENT
Place the machine on a level place.
Place a container under the engine.
Remove the oil filler bolt and drain plug to
drain the oil.
Reinstall the drain plug and tighten to
specification.
Torque: 18 N-m (1.8 kgf-m, 13 lbf-ft)
Fill the engine with oil and install the oil
filler bolt.
Torque: 18 N-m (1.8 kgf-m, 13 lbf-ft)
Oil Capacity:
At disassembly:
0.12 L (0.11 lmp qt , 0.13 US qt)
At change:
0.11 L (0.1 lmp qt , 0.12 US qt)
＊
Be sure no foreign material enters the
crankcase.
Start the engine and warm up for a few
minutes. While warming up, check for oil
leakage. If oil leakage is found, stop the
engine immediately and check for the cause.
3-11
Oil Filter Bolt/Measurement Hole
Drain Plug