WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
Control board #6100499 with Code Date MGR/
0245 (45th week, 2002), or higher, will allow ice
thickness adjustments. The approximate ice
thickness settings are as follows:
Ice Thickness @ Normal = 0.32" (8.1 mm)
Ice Thickness @ Thin = 0.28" (7.0 mm)
Ice Thickness @ Thick = 0.39" (9.9 mm)
ADJUSTING THE ICE THICKNESS
Ice thickness is controlled by the placement of
a jumper at P4 on the control board. The
jumper positions for the three ice thickness
settings are shown below. NOTE: If the jumper
is missing, or in any position other than those
shown below, the unit will produce normal ice
thickness.
2
3
Normal
Ice Thickness Jumper
Jumper At P4 Shown In The
Factory Default (Normal) Position
8-3
1
4
5
2
Thick
Thin
1
4
2
5
3
4