Graco ULTRA PLUS+ 1500 Instruction Manual page 6

Setup
sure the hoses are electrically conductive, that the
If you supply your own hoses and spray gun, be
gun has a tip guard, and that each part is rated
for at least
3000
psi
(210
bar) Working Pressure.
This is to reduce the risk of serious injury caused
by static sparking, fluid injection or over-pressur-
izat!on and rupture of the hose or gun..
A
CAUTION
To avoid damaging the pressur; control, which
may result in poor equipment performance and
component damage, follow these precautions:
1. Always use a nylon spray hose at least
50
ft.
(15 m) long.
2. Never use a wire braid hose as it
is
too rigid to
act as a pulsation dampener.
3. Never install any shutoff device between the
filter and the hose. See Fig. 2.
1. Assemble the gun (106), 3
ft.
whip hose
(105)
and tip guard yet.
and
50
ft. hose (104). Don't install the spray tip
2. Two gun hookup. Remove
the cap
(12) from the
minimum 50
ft.
long hose. For more flexible gun
1/4 npsm(m) secondary hose outlet and attach a
between the main hose and the gun.
movement, install a 3/16 in. ID, 3
ft.
whip hose
3. Fill the packing nut/wet-cup (216) 113 full with
Graco Throat Seal Liquid (TSL), supplied.
FIRE AND EXPLOSION HAZARD
Proper electrical grounding is essential
to reduce the risk of fire or explosion
which can result in serious injury and
property damage.
Also
read FIRE OR
EXPLOSION HAZARD on page 4.
4. Check the electrical service.
Be
sure the electri-
erly grounded outlet. Do not remove the ground-
cal service is 120 VAG, 60 Hz, 20A. Use a prop-
ing prong of
the
power supply cord. Do not use
an adapter. Extension cords must have 3 wires
of
a minimum 12 gauge size. Long extension cords
available, flip the 15/20 Amp switch (U) to 15 set-
reduce sprayer performance. If 20A service is not
ting to avoid nulsance tripping
o f
circuit breakers.
5. With the the ON/OFF switch OFF, plug the cord
into
a
grounded electrlcal outlet located at least
20
ft.
(6 m) away from the spray area.
6. Flush the pump to remove the lightweight oil
which was
left
in to protect pump parts after fac-
tory testing. See page 9.
A
Do
not install any
1
fluid
shutoff
device
here
Fig. 2
K
104
'05
01888
6
308-551