Honeywell TURBO FORCE HT-900 Series Owner's Manual page 2

16. Do not operate if the fan housing is
removed or damaged.
17. A loose fit between the AC outlet
(receptacle) and plug may cause
overheating and a distortion of the plug.
Contact a qualified electrician to replace
loose or worn outlet.
18. Do not operate any fan with a damaged
cord or plug. Discard any damaged fan,
or return the fan to the retailer where the
fan was purchased, or request a return
authorization to return to Kaz USA, Inc.
for examination and/or repair.
FUSED SAFETY PLUG - FOR US MODELS ONLY
This fan features a fused safety plug which is designed to cut off electric current to the fan if an
electrical fault occurs. Please see below for more information on how to properly use your fan and
replace the safety plug fuse, if needed.
USER SERVICING INSTRUCTIONS
• If your fan loses power and you suspect that the fuse on your fan
has blown, grasp plug and remove from the receptacle or other
outlet device. Do not unplug by pulling on cord.
• Slide fuse cover, located on the top of the plug, towards the prongs
of the plug. (Fig. 1)
• Carefully remove the blown fuse and snap a new fuse into place. To
reduce the risk of fire, replace fuse only with 2.5 Amp, 125 volt fuse.
Fully close the fuse door by sliding back into place. Discard the blown
fuse. The plug should now be ready for normal use. (Fig. 2)
• To reduce the risk of fire, do not replace attachment plug. Contains
a safety device (fuse), that should not be removed. Discard product
if the attached plug is damaged.
• If you need further information on how or when to replace the fuse in
the safety plug, please contact Kaz Consumer Relations Department
by visiting our website at www.honeywellpluggedin.com/fans or
calling 1-800-477-0457.
INTRODUCTION
The Turbo Force ® High Velocity Air Circulator Fans are aerodynamically
designed to give you the versatility of changing this fan's angular direction
simply by adjusting the fan to ANY desired angular output (Fig.3). Upon
using this fan, you will feel a strong and powerful air stream that will
quickly move air to provide a cooling effect.
19. Do not run fan cord under carpeting. Do
not cover cord with throw rugs, runners,
or similar coverings. Do not route cord
under furniture or appliances. Arrange
cord away from traffic areas and where
it will not be tripped over.
WARNING:
To Reduce The Risk
of Fire or Electric Shock, Do Not Use
This Fan With Any Solid State Speed
Control Device
Fig. 1
Fig. 2
Fig. 3
FOR ENERGY SAVINGS ALL YEAR
Honeywell Air Circulator Fans can help save energy and can lower
monthly utility bills all year round. Our air circulators increase
distribution of cooler air from your air conditioner or warmer air
from your heating system, creating a vortex of air flow for increased
comfort. Increased air flow allows the air conditioning and heating
systems to be used at lower settings to help save you money.
In the summer:
Circulate cool
air by using
with window
or central air
conditioning.
Circulate cool
air upstairs.
In the winter:
Circulate warm
air. Position your
air circulator in
an open location
for upward air
movement.
Run it on a low
setting to move
the hotter air
from the ceiling
and circulate
the warmer air
throughout the
room.
Increase Heating Source Efficiency: Use
with other heat sources, such as wood stoves,
baseboard heaters, and or vents to help circulate
the warm air throughout the room.