Ignition Power Management Quick Guide - JHCTech FEBC-3150 User Manual
Aluminum chassis , fan less design, intel core 4th gen i3/i5/i7 processor, 2xddr3l 1600 sodimm, max 16gb, 3xmini pcie support 3g/lte/wifi/bt/gps/can, dvi-i/hdmi/vga display, 4xcom/8bit dio/4xusb/audio, 4xintel i210-it power over ethernet, 1xmsata and 2x2.
Table of Contents
Advertisement
5.1 Ignition Power Management Quick Guide
Startup/shutdown conditions from the IGNITION signal:
◆ IGNITION startup signal must be valid during 3 sec. (anti‐noise protection).
◆ IGNITION shutdown – IGNITION signal must be inactive during 3 Sec, then PIC
controller initiate Power Button signal
Power
Button). It generate Main Button shutdown event and then goes to
complete power off.
Typically the system can start only from IGNITION signal, because startup PIC controller is
disconnected from the power source.
The system can be switched off from:
◆ Power IGNITION OFF signal.
◆ ACPI OS shutdown
◆ Power Button – generate ACPI event (OS dependent).
(OS must be set to shut down from the
Power Ignition Startup Procedure
Power Ignition Shutdown Procedure
26
User's Manual
Advertisement
Table of Contents
