Folding The Unit - Genee 6100 Manual

Connect the visualiser to a computer with a RS232 cable (Please
disconnect the projector from the RS232 port first) and select the
Baud Rate and Parity based on the projector's Baud Rate, then click
the "TEST" button to pop up the Projector Code Test dialog box, input
the Baud Rate and Parity based on the projector's Baud rate, then
click "Open".
Click the projector control buttons on the visualiser's operating panel
to check if the control code that the program received is the same as
the sending code. If the receiving code is same to the sending code,
the input codes are correct. If the visualiser cannot control the
projector, please do the following.
1. Check to see if the source control codes of projector are correct.
2. Check to make sure the connection between the visualiser and the
projector is correct.

FOLDING THE UNIT

1. Fold the right arm light down first onto the base, then the left arm
down. Rotate the camera head clockwise until the camera head is
parallel to the camera stand.
24