Microplex SOLID T8 Operator's Manual page 5

_______________________________________________________________________________________________
Chapter
6.21. Symbol Code Selection
6.22. Paper Change and manual Material Transport (Paper Move)
6.23. Print Speed Adjustment
6.24. Contrast (Density) Setting
6.25. Setting the Zero Position of the Material Feed (Sync Sensor Offset)
6.26. Setting the Sync Sensor Mode
6.27. Setting the Sync Sensor Level
6.28. Setting the Sync Sensor Sensitivity
6.29. Selecting the Light Sensor Type
6.30. Selecting the Cut Mode
6.31. Adjusting the Cutting Position
6.32. Configuration of Network Parameters (f.e. IP Address)
7. Operator Maintenance
7.1. Printer Cleaning
7.1.1. Printer Cabinet Cleaning
7.1.2. Printhead Cleaning
7.1.3. Sensor Cleaning
7.1.4. Transport Roller Cleaning
7.2. Printhead Exchange
7.2.1. Printhead Removal and Installation
7.2.2. Head Resistance Value Setting
7.3. Adjusting the Right Pressure Value
8. Troubleshooting
8.1. Error Messages
8.2. Reduced Print Quality
8.3. Incorrect Media Transport
8.4. Print Repetition after an Error
9. Specifications
10. Index
_______________________________________________________________________________________________
MICROPLEX Operator's Manual SOLID T4 / T5 / T6 / T8
Contents 5
Page
72
73
74
75
76
78
79
80
81
82
86
87
89
89
90
91
92
92
93
94
97
100
102
102
103
105
106
107
111
Edition 2.0