Grandstream Networks GWN7610 User Manual page 40

Gateway MAC Address
RSSI Enabled
Minimum RSSI (dBm)
Enable Voice Enterprise
Enable 11R
Enable 11K
and they cannot access any of the management services on the
GWN7610 access points.
•
Radio Mode: Wireless clients can access to the internet services,
GWN7xxx router and the access points GWN7610 but they cannot
communicate with each other.
This field is required when using Client Isolation, so users will not lose
access to the Network (usually Internet).
Type in the default LAN Gateway's MAC address (router's MAC address
for instance) in hexadecimal separated by ":".
Example: 00:0B:82:8B:4D:D8
Check to enable RSSI function, this will lead the AP to disconnect users
below the configured threshold in Minimum RSSI (dBm).
Enter the minimum RSSI value in dBm. If the signal value is lower than the
configured minimum value, the client will be disconnected. The input range
is from "-94" or "-1".
Enable this feature to help clients connected to the GWN7610 to perform
better roaming decision.
•
The 802.11k standard helps clients to speed up the search for
nearby APs that are available as roaming targets by creating an
optimized list of channels. When the signal strength of the current
AP weakens, your device will scan for target APs from this list.
•
When your client device roams from one AP to another on the
same network, 802.11r uses a feature called Fast Basic Service
Set Transition (FT) to authenticate more quickly. FT works with
both pre-shared key (PSK) and 802.1X authentication methods.
•
802.11v allows client devices to exchange information about the
network topology,
environment, making each client network aware, facilitating
overall improvement of the wireless network.
Note: 11R is required for enterprise audio feature, 11V and 11K are
optional.
Check to enable 802.11r
Check to enable 802.11k
GWN7610 User Manual
Version 1.0.5.15
including information about the RF
P a g e |
40