Assembly Of The Grass Catcher; Preparations For Assembling The Under Rops Pipe; Installing The Under Rops Pipe - Kubota GZD21-2 HD Assembly Manual

ASSEMBLY OF THE GRASS CATCHER

CONTAINER
<High Dump>
BPreparations for Assembling the Under
ROPS Pipe
1. Make a team of two to do this job.
2. Remove the bolt (1) and nut (2) from the lift rod (for
both sides).
The bolt (1) will be used again to reassemble this
component. Be careful not to lose them. (The nut (2)
will not be reused.)
(1) Bolt
(2) Nut
(3) Lift rod
(4) Under ROPS pipe
BInstalling the Under ROPS Pipe
1. Remove the snap pin (1) that keeps the cylinder (A) in
place.
(1) Snap pin (A) Cylinder
2. Remove the 4 bolts (2) first and then the fixing plate
(1). (The same for both sides)
4 bolts (2) will not be reused.
(1) Fixing plate
(2) Bolt
3. Using the bolts (3), temporarily connect the pipes
(ROPS, UNDER) (1) to the frame (3). (4 bolts each for
each side)
Fix the cylinder (2) to the frame (A) with the headed pin
(4) and snap pin (5).
(1) PIPE, ROPS UNDER
(2) Cylinder
(3) Bolt (M14 x 30)
(4) Headed pin
(5) Snap pin
7
(A) PIPE, ROPS UNDER
(B) Frame
(A) Frame