Information - Honeywell Sensepoint XCD RTD Technical Manual

Sensepoint XCD RTD Technical Manual SPXCDHMRTEN Issue 1

2 Information

This manual is applicable only for the Sensepoint XCD RTD version of the Sensepoint
XCD product range.
Where "Sensepoint Toxic" is mentioned throughout this manual, it refers to the Honeywell
Analytics Sensepoint product range of Toxic AND Oxygen gas sensors.
The Start-up/Surge/In rush current is dependant on the type of power supply used. The
typical start-up current for Sensepoint XCD RTD is less than 800mA. Measure the start-
up current using the specific power supply before installation to ensure suitability for your
application.
Honeywell Analytics can take no responsibility for installation and/or use of its equipment if
not done so in accordance with the appropriate issue and/or amendment of the Technical
Manual.
The reader of this Technical Manual should ensure that it is appropriate in all details for the
exact equipment to be installed and/or operated. If in doubt, contact Honeywell Analytics
for advice.
The following types of notices are used throughout this Technical Manual:
WARNING
Identifies a hazardous or unsafe practice which could result in severe injury or
death to personnel.
Caution: Identifies a hazardous or unsafe practice which could result in minor injury
to personnel, or product or property damage.
Note: Identifies useful/additional information.
Every effort has been made to ensure the accuracy of this document, however, Honeywell
Analytics can assume no responsibility for any errors or omissions in this document or
their consequences.
Honeywell Analytics would greatly appreciate being informed of any errors or omissions
that may be found in the content of this document.
For information not covered in this document, or if there is a requirement to send
comments/corrections about this document, please contact Honeywell Analytics using the
contact details given on the back page.
Honeywell Analytics reserve the right to change or revise the information supplied
in this document without notice and without obligation to notify any person or
organization of such revision or change. If information is required that does not
appear in this document, contact the local distributor/agent or Honeywell Analytics.
3