Table of Contents
Advertisement
To program/reprogram an
outside number,
extension, or feature code
into a personal list
To place a call using an
AD list button or code
1
On a separate sheet of paper, jot down the outside
numbers, extensions, and/or feature codes you want
to program as items on your personal list(s) (see
example to the left)
Note: Each telephone number or feature code is
stored as a separate item.
2
Press [
Program
or Dial AD Program code
Dial Personal List number (1, 2, or 3)
3
4
Dial list item (1, 2, 3,..)
5
Dial number you want to store (up to 24 digits)
Note: If you are programming an outside number,
be sure to include a trunk code, if applicable.
6
Press [
]
#
Repeat Steps 4-6 if you want to program
additional items on the same list; press [
and begin again at Step 1 if you want to program
items on another list
7
Hang up or press [
Note: Record your personal list items on the
Abbreviated Dialing list in the back of this booklet;
group, system, and enhanced lists can be obtained
from your System Manager.
1
Press [
Pers List
or Dial appropriate AD List code:
List 1
List 2
List 3
Note: An [
Enhcd List
you System Manager.
Dial desired list item (1, 2, 3...)
2
Call is dialed
]
] to end programming
Drop
] or [
] or [
Grp List
] may also be available; see
[dial tone]
[dial tone]
[dial tone]
[confirmation tone]
]
Drop
]
Sys List
[dial tone]
10
Advertisement
Table of Contents
