MG MGA Twin Cam Workshop Manual page 28

SECTION A
THE ENGINE
General description.
Lubrication system.
Section No. A. I Draining the sump.
Section No. A.2 Oil pressure.
Section No. A.3 Oil pressure relief valve
Section No. A.4 Water pump.
Section No.
A.S
Carburetters.
Section No. A.6 Inlet manifold.
Section No. A. 7 Header tanlc.
Section No. A.8
Section No.
A.9
Section No. A.IO
Section No. A. II
Section No. A.l 2
Section No. A.l3
Section No. A.l4
Section No. A. IS
Section No. A.l6
Section No. A. l 7
Section No. A. IS
Section No. A.19
Section No. A.20
Section No. A.21
Section No. A.22
Section No. A.23
Section No. A.24
Section No. A.25
Section No. A.26
Section No. A.27
Section No. A.28
Section No. A.29
Section
No. A.30
Section No. A.31
Section No. A.32
Section No. A.33
Section No. A.34
Section No. A.35
Section No. A.36
Section No. A.37
Section :-lo. A.38
Section No. A.39
Section No. A.40
Section No. A.41
Section No. A.42
Section :-lo. A.43
Section No. A.44
End of Section
MGA (Twin Cam) Issue 6. 3463l
Thermostat housing.
Exhaust manifolds,
Camshaft driving sprockets.
Camshafts.
Camshaft bearings.
Cylinder head.
Decarbonizing.
Valves.
Valve guides.
Valves and seatings.
Tappet clearances.
Valve timing-<:becking and adjusting.
T iming chain-adjusting.
Timing chain cover.
Timing chain.
Engine front plate.
Power unit- removing and replacing.
Sump and oil pump strainer.
Maio and big-end bearings.
Pistons and connecting rods.
Piston rings.
Half-speed shaft.
Diuributor
drive gear.
Oil pump.
Flywheel.
Cranlcshaft.
Camshaft locking tool.
Flywheel starter rings.
Connecting rod assemblies.
Modified engine mounting.
Modified half-speed shaft and oil pump driving spindle.
Modified pistons and rings.
Modified crankcase breather pipe.
Modified tappets.
Modified timing cover gasket.
Alternative pistons.
Piston and piston ring history.
Service tools.
A
A . l