Table of Contents
Advertisement
SmartNode 4130 User Manual
Configure the Desired IP Address
Factory-default IP Settings
The factory default configuration for the Ethernet interface is listed in
(WAN) has a DHCP client running and a fixed IP address.
Table 6. Factory Default IP Address and Network Mask Configuration
WAN Interface Ethernet 0 (ETH 0/0)
Fixed IP
DHCP client
If these addresses match with those of your network, go to section
page 31. Otherwise, refer to the following sections to change the addresses and network masks.
Login
To access the SmartNode, start the Telnet application. Type either the default IP address into the address field
of the Telnet application:
192.168.1.1
Or use the
SN Discovery Tool
Accessing your SmartNode via a Telnet session displays the login screen. Type the factory default login: admin
and leave the password empty. Press the Enter key after the password prompt.
login:admin
password: <Enter>
192.168.1.1>
After you have successfully logged in you are in the operator execution mode, indicated by > as command line
prompt. With the commands enable and configure you enter the configuration mode.
192.168.1.1>enable
192.168.1.1#configure
192.168.1.1(cfg)#
Changing the WAN IP address
Select the context IP mode to configure an IP interface.
192.168.1.1 (cfg) #context ip ROUTER
192.168.1.1 (ctx-ip) [ROUTER} #
Now you can set your IP address and network mask for the interface ETH 0/0 (WAN). Within this example a
network 172.16.1.0/24 address is assumed. The IP address in this example is set to 172.16.1.99 (you should set
the IP address given to you by your network provider).
Configure the Desired IP Address
to find out the IP address previously assigned by the DHCP server.
table
6. The interface bound to ETH 0/0
IP Address
192.168.1.1
DHCP
"Loading the Configuration (optional)"
4 • Initial Configuration
Network Mask
255.255.255.0
DHCP
on
30
Advertisement
Table of Contents
