Graco L20c Operation page 31

Disconnected Solenoid Diagnostic Code
Screen
See F . 28. If the system detects a disconnected air
IG
motor solenoid and the E4 Diagnostic Code is enabled,
the Disconnected Solenoid screen becomes active.
F . 28: Disconnected Solenoid Diagnostic Code
IG
Screen
1. Press and release
Solenoid screen.
2. Correct the condition causing the diagnostic code;
see T 4, page 33.
ABLE
3. This diagnostic code will automatically clear when
the system detects that the solenoid is connected.
to exit the Disconnected
Drum Low/Empty Diagnostic Code Screen
See F . 29 and F . 30. If the drum low/empty sensor
IG IG
trips, the Drum Low or Drum Empty screen becomes
active, depending on which sensor setting is chosen,
see page 28.
F . 29: Drum Empty Diagnostic Code Screen
IG
F . 30. Drum Low Diagnostic Code Screen
IG
1. Press and release
screen. This will set the diagnostic code as a stand-
ing diagnostic code. A standing diagnostic code has
not been cleared, simply acknowledged.
2. Replace the low or empty drum with a full drum.
When the sensor no longer detects a low or empty
drum the diagnostic code will clear automatically.
Remote DataTrak Operation
to exit the Drum Low/Empty
31